Sartorius YDP30 Betriebsanleitung Seite 12

Getting Started
5.4 Switching the Device On or Off
Procedure
To switch the device on: Press the On/Off switch so that it is
t
in the "I" position .
When the device is connected to a network: The device
y
establishes a connection to the Wi-Fi network or corporate
network and retrieves an IP address for the device . This
procedure usually takes 20 seconds .
The LED display illuminates in the color "yellow" .
y
If media and an ink ribbon are inserted into the device: The
y
device will print an initial printout containing the Sartorius
logo and the current software version .
The LED display illuminates in the color "green" . The device
y
is ready for use .
To switch the device off: Press the On/Off switch so that it
t
is in the "O" position .
5.5 Opening or Closing the Top Cover
Requirements
The device is switched off .
Procedure
Open the top cover upward and push it backward until
t
it stops .
The top cover lock audibly engages .
y
To close the top cover:
t
Push sideways against top cover lock . This will unlock
t
the top cover .
Push the top cover back down . Both levers should snap
t
into place .
12 Operating Instructions YDP30 | YDP30-NET
To open the top cover:
t
Pull the levers located
t
on both sides of the top
cover forwards .
5.6 Inserting Media into the Device
5.6.1 Inserting Media into the Media Mount
The media spool, e .g . the standard paper roll, must be inserted
between the 2 media mounts . The print side of the media must
be facing up .
Requirements
− The print roller is clean (see Chapter "7 .2 Maintenance
Schedule", page 16) .
− The device is switched off .
Procedure
Check if the media are suitable for the device (suitability,
t
see Chapter "13 .7 Ink Ribbon", page 25) .
Open the top cover .
t
Push the 2 mounts apart and fix the media spool between
t
the mounts .
Turn the setting wheel for the media feed so that the media
t
feed is set to the width of the inserted media .
Close the top cover .
t
Check if the media mount is
t
set to the right media spool
size .
If required: Push the
t
2 mounts apart and turn
them 180° .
Push the media over the
t
media feed, the sensor for
black marking and the print
roller .