ANSMANN LED-BALL-WORKLIGHT Bedienungsanleitung Seite 7

ƒ Do not open or modify the product! Repair work shall only be
carried out by the manufacturer or by a service technician
appointed by the manufacturer or by a similarly qualified
person.
ƒ Disconnect the device from the power supply only by
pulling on the plug or plug housing, never on the cable.
ƒ Information for the light and mains adapter as well as
mains voltage on the socket must match with the type
plate.
ƒ The lamp shall not be placed face-down or allowed to
topple face-down.
CLEANING | OPERATION
Before cleaning the light, disconnect the mains plug and
allow the spotlight to cool down sufficiently. Clean with
a dry or slightly damp, clean, lint-free cloth. Before each
use, check the plug, mains cable and housing of the lamp
for damage. If the lens is damaged, it must be replaced
immediately. Clean any dirt from the housing or lens
immediately as this may cause overheating.
ENVIRONMENTAL INFORMATION DISPOSAL
Dispose of packaging after sorting by material type.
Cardboard and cardboard to the waste paper, film to
the recycling collection.
Dispose of the unusable product in accordance with
legal provisions. The „waste bin" symbol indicates
that, in the EU, it is not permitted to dispose of elect-
rical equipment in household waste.
For disposal, pass the product on to a specialist
disposal point for old equipment, use the return and
collection systems in your area or contact the dealer
from whom you purchased the product.
Improper disposal may result in toxic ingredients
being released into the environment, which may
have adverse health effects on humans, animals and
plants.
In this way you will fulfil your legal obligations and
contribute to environmental protection.
PRODUCT DESCRIPTION
1. Carry handle
2. Cable winder
3. On/off switch
4. Integrated socket with protective cover
5. Base
6. Mains plug
7. Protective cover
8. Integrated hanging hook
FIRST USE / OPERATION
Plug the mains plug in to a mains power outlet. The on/
off switch is on the side of the housing.
The lamp shall be set down only on stable and non-slip
surfaces that are as close to horizontal as possible.
When placing it on slight inclines ensure that the lamp
cannot topple over.
Deutsch |
Italiano | Nederlands | Dansk | Suomi | Norsk | Polska
HOLDING DEVICES (HOOKS, STAND, ETC.)
If the light is the to be fastened with a holding device,
ensure that the holding device is firmly/properly fastened
in place. Observe max. mounting height! (Stand and
fastening materials not included).
INTEGRATED SOCKETS
Do not connect devices with a combined power rating
over 3000W (total output power for the socket) to the
integrated socket. IPX4 is only assured when an IPX4 plug
is connected to the device socket or the cover of the
socket is closed.
Subject to technical changes. We assume no liability for printing errors.
English
| Français | Español | Português | Svenska
The product complies with the requirements from the
EU directives.