Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Usuage
The usuage of both plates is identical. Place a suitable pot/pan (min. diameter 12cm)
in the middle of the intended cooking zone. Plug in the appliance.
Attention: Do not place any hot pots or pans on the touch control area.
Stand-By-Mode
Press the On/Off button
plate. If there is no program chosen within one minute, then the appliance returns to
the stand-by mode, two lines are flashing above the timer.
If the appliance is build in, then it must be taken care, that the ventilation openings
are not covered and sufficient air can get to the housing, as it else can overheat.
Power
Press the button
for the back plate or the button
play „E" and „0" is alternating flashing when no pot or a non suitable pot is on the
cooker.
By pressing the
Back plate:
1 = 500W, 2 = 800W, 3 = 1.000W*, 4 = 1.100W,
5 = 1.300W, 6 = 1.500W, 7 = 1.600W, 8 = 1.800W
Front plate:
1 = 400W, 2 = 500W, 3 = 800W, 4 = 900W,
5 = 1.000W, 6 = 1.100W, 7 = 1.200W, 8 = 1.300W
The appliance is equipped with an overheating protection. When the pots/pans
get too hot, then the appliance will switch off, a buzzer sounds and on the display
appears E02.
In that case, the "On/Off"
down some minutes. After that the appliance is working without problem again.
. A line is flashing at the diplay at the upper und lower
button the Wattage can be changed in steps.
button should be pressed and the appliance should cool
for the front plate. In the dis-
9
Werbung
Inhaltsverzeichnis
