Inoksan BYM052B Gebrauchsanweisung Seite 10

 Apply the manufacturer's remarks on the
detergent dosage according to the water hardness.
 The wash water must be renewed at least 3 times a
day or when the water loses its ability to clean due
to dirty particles. Washing performed with dirty
wash water causes bad washing results, along
with detergent, polisher and power wastage.
 Do not dry cleaned dishes with a dirty towel.
 Do not place clean dishes on spongy towels or
other materials.
 Use disposable materials or preferably the basket
system.
USING THE MACHINE

 6.1- Running
1. READY
2. ON/OFF
3. P1 : 1. short program 80 sec
After the machine's power plug is inserted,
"2 ON / OFF button is pressed and" 1 READY
"until the position is expected. The machine is
ready for operation.
ATTENTION : This position starts washing
detergent but turning it to the position P1,
since water is cold
Wait for the 1 READY "lamp to light up for best
results.
 P1-Short Wash (90 sec) : For dishes with low
dirt
 P2-Medium Wash (120 sec) : For dirty dishes
 P3-Long wash (180 sec.) : For oily and dirty
dishes
You can select one of the programs "P1, P2 and
P3". Recommended washing duration is 110 sec.
and recommended water temperature is 55ºC.
At the start of operation, when the temperature
reaches 55ºC, "washing temperature reached
signal light" turns on. After the light turns on, an
appropriate program is selected. As long as the
All manuals and user guides at all-guides.com
10
 Make the constant cleaning of the shelves that you
use for storing dishes with special detergents and
disinfectants available in the market.
NOTE: The choice of detergent can be a
determining factor in getting a good wash result,
protection and lifetime of the machine. Therefore
we recommend
contaminating products and not exceeding the
suggested detergent amount.
4. P2 : 2. medium program 110 sec
5. P3 : 3. long program 140 sec
6. DRAIN
washing continues, the "in wash" signal light stays
on.
1. Select the most suitable program according to
the type and/or dirtiness of the dishes to be
washed.
2. Select the relevant tray according to the dishes
to be washed and load them according to the
capacities stated on the chart. Do not start the
device without entirely filling the tray in order
to save detergent and power.
3. Never change the location of the device while
it is operating.
4. Be sure that the water input valve is open
before operating the device.
DRAINING:

Lid opens
 Stopper is removed

ON "ON / OFF" button numbered 2 is
turned off.

Press the "DRAIN" button number 6 once.

Tah Evacuation of the device begins
not using abrasive or