Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Quick installation guide IB-1817MC-C31
2. Usage
1.
Connect the IB-1817MC-C31 via the delivered cable to the correspon-
ding port of your host computer.
2.
When the IB-1817MC-C31 has been plugged in correctly, the LED will
light up white.
3.
As soon as the write protection has been activated by switch, the LED
lights up red*.
*Important! A change of the write-protect mode will only be activated
when the device has been disconnected and then reconnected to the host
computer.
3. Application
1.
An external SSD can be connected to or disconnected from the com-
puter without shutting down the computer.
2.
Please await the end of read/write operations before disconnecting
the SSD to avoid data loss.
3.
A new SSD must first be initialized, partitioned and formatted by the
operating system to be displayed by the system.
4.
If the drive is not recognised instantly by the operating system, please
check:
- if the driver software is installed (USB)
- if the SSD is initialized, partitioned and formatted.
Info: Drives must be initialized and have active partitions to be immediately
recognised as volumes in the operating system. If this is not the case, initialize
the drives in the volume management of your operating system.
•
The external drive can be connected to or disconnected from the com-
puter via USB cable without shutting down the computer.
•
Please await the end of read/write operations before disconnecting
the drive to avoid data loss.
The full USB 3.2 Gen 2 transfer rate can only be achieved with a compatible
USB 3.2 Gen 2 host computer. Furthermore, the USB 3.1 drivers must be
installed by the operating system. If this is not the case, install the appropriate
drivers for your operating system (Windows
For more information, please visit www.icybox.de.
, macOS
).
®
®
Werbung
