Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
use
STICK MIXER
Attention: the blade of the stick mixer foot is very sharp.
• Take the motor unit and stick mixer foot. Attach the stick mixer foot to the motor unit by turning
it clockwise.
• To remove it, you must turn the stick mixer foot in the opposite direction.
• Insert the plug in the socket.
• Insert the stick mixer foot in the food to be mashed.
• Press the on/off button for position I or II.
• When you let go of the button, the stick mixer will stop.
• When you are ready mixing or mashing and have let go of the button, wait for the blade to stop
rotating before touching the stick mixer foot.
Caution: do not switch on the stick mixer constantly, this could cause problems with the motor.
Preferably use the stick mixer one minute each time and then allow the stick mixer to cool down for one or two minutes. If
you want to mash large volumes, you should do this in several turns.
Switch on the appliance for a maximum of 15 seconds per time when it is not being used to mix or mash food.
Always remove the plug from the socket when you leave the appliance unsupervised and before you assemble, disassemble
or clean the appliance.
The stick mixer can be used directly in a pan or bowl. Remove the pan from the hotplate to prevent the stick mixer from
overheating.
WHISK
The whisk is intended for whipping cream or egg whites.
• Take the motor unit, coupling piece and whisk.
• Insert the whisk in the coupling piece.
• Attach the whisk to the motor unit by turning it clockwise.
• Insert the plug in the socket.
• Pour the ingredients to be whipped in a measuring cup.
Make sure there is not too much filling in the measuring cup.
• Place the whisk inside the measuring cup.
• Press the on/off button for position I or II.
• When you let go of the button, the whisk will stop.
Always remove the plug from the socket when you leave the appliance unsupervised
and before you assemble, disassemble or clean the appliance.
To remove the whisk after use, turn the coupling piece counter-clockwise to remove
it from the motor unit and pull the whisk out of the coupling piece.
MINCER
Attention: the blade of the mincer is very sharp. Be careful when assembling, emptying the bowl and cleaning.
The mincer is suitable for mincing or grinding meat, cheese, onions, herbs, garlic, carrots, nuts, etc.
Attention: do not grind hard ingredients such as ice cubes.
• Place the ingredients in the mincer.
• Place the cover on the mincer and turn it clockwise until it snaps tight.
• Take the motor unit and turn it clockwise to attach it to the mincer's cover.
• Insert the plug in the socket.
• Press the on/off button for position I or II.
• While mincing, hold the motor unit with one hand and the mincer with the other hand.
Caution: do not switch on the mincer constantly, this could cause problems with the
motor.
• Preferably use the mincer one minute each time and then allow the motor unit to cool
down for one or two minutes.
• When you let go of the button, the mincer will stop. Wait until the blade stops rotating,
before you unscrew the cover with motor unit from the mincer.
Always remove the plug from the socket when you leave the appliance unsupervised and
before you assemble, disassemble or clean the appliance.
In order to remove the motor unit after use, unscrew it counter-clockwise from the cover.
13
English
•
Werbung
Inhaltsverzeichnis
