Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I. The machine does not respond when powered on.
1.Power connection failure: check the socket, switch and socket on the machine body to ensure that they have been properly plugged and
connected to power; check the Power button on the panel to make sure it is pressed and the button light is on.
II. Unable to connect to the computer
1. Not connected to the USB cable: check the computer and machine intertace of the USB cable to ensure that it is properly connected. The
USB interface on the front panel of some desktop computers is invalid, so it needs to be connected to the socket at the rear of the host.
2. The driver is not installed properly: install the driver according to the instructions. If the computer identifies the device as a serial port after
installation, the hardware connection is OK.
3. Other special cases: disconnect the USB cable and power supply. Atter the equipment is completely powered off for 5 seconds, connect it to
the power again.
Ⅲ. Light carving or no carving
1. Inaccurate focusing: read the focusing section of the Operations Manual for accurate focusing.
2. Carving speed: a result of too high speed or too short burning time. Read the carving parameters section of the Operations Manual to
readjust the parameters.
3. Shallow picture: the imported picture needs to be clear. If the lines too fine and the color is too light, the carving effect will be atfected
directly.
4. Placement of object: as the laser focal distance is fixed, the object to be carved needs to be flat, parallel to the machine body. If the object
to be carved is titled, the focal distance is inaccurate, resulting in abnormal carving effect.
FAQ
Werbung
