Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Part 10：Software Acquisition and Installation
Method 1:
1. Turn on the power of the marking machine and use the data cable to connect the computer where the marking software needs to be installed;
2. Open the attached U disk on the computer, extract the "BSL engraving software" file to the computer desktop, open the unzipped folder,
and send "ATOMSTACK" to the desktop shortcut;
3. Install the driver file "Drive\win7win8win10-x64.exe" in the U disk. After successful installation, double-click the desktop shortcut
"ATOMSTACK" to start the engraving software.
Method 2:
In the event that the attached U disk is lost or the software is deleted by mistake, users can log in to the official website
www.atomstack.com
to obtain the software. Installation steps are the same as the method
Software Opened Page
Werbung
