spavida C667 Montageanleitung Seite 27

8.Fault elimination:
Fault
1.The volume is adjusted too low.
No sound from
2.The adapter of loudspeaker has
louds peaker
been loosened.
3.The loudspeaker is damaged.
Failure of
The remote cnotrol has low battery
remote control
1.The creepage protection plug has
The machine
not been electrif ied.
cannot be
2.The control line between controller
activated
and electric bos has not been
connected properly.
Underwater
1.The wiring for underwater lamp
lamp does
is loosen;
not light up
2.The bulb is damaged.
1.The antenna has not pulled out;
Poor radio
2.The radio frequency has not
result
been adjusted properly;
3.The user is in weak signal area.
9.ITEMS FOR ATTENTION:
1.The system must be erected by qualif ied technical personnel and the creepage protection
switch plus shall be mounted in a place of easy control.
2.It must be connected firmly during erection.In the case of Ioss due to improper earthing,
the manufacturer will not assume any responsibility.
3.The motor must be erected f latly and stably and the shell shall be f irmly earthed.
4.The whole set is usually under standby state.If it is not used for long time,please pull off the
master power switch.
5.During erection,it is required to consider load capactity of power supply circuit,otherwise
it may, inf luence the normal working of the system or cause accident.
6.During erection,all the electric appliances and electric parts shall be provided with
moistant resistant measures.
27
Fault cause Solution
1.Increase the volume
2.Reconnect the wire properly
3.Replace the loudspeaker
Replace the battery
1.Check if creepage protection plug
indicating lamp has been
extinguished.If the answer is yes,
reconnect the power supply.
2.Reconnect the computer line
properly
1.Reconnect the wire properly;
2.Replace with new bulb.
1.Pull out the antenna and place
properly;
2.Readjust radio frequency
properly;
3.It is influenced by geographical
position.