spavida C667 Montageanleitung Seite 18

Trouble analysis and obviation
Phenomenon
1. The air switch is not tight, and leak
pressure.
2.Air switch are ineffective.
The water
pump does
3.The plug not be inserted or power
not operate
supply abnormally.
4.There are sundries
that blocks the water pump impeller.
5.The water level not reached the height
stipulated.
1. Power supply is abnormal.
2. The strength adjusting does not act.
Can't adjust
3.The large air pipe not been inserted
the massage
closely.
strength
1.Seal gasket is not good.
2.The nut not been locked tightly,
The water
interface place sticking is bad.
pipe leaks
3.The inner layer in the water pipe
breaks.
1.The fuse of the light is melted.
2. No water in the bathtub or the
The
submarine
water not high enough.
light is not
3.The light bulb has been out of order.
bright
18
Reason Solution
1.Insert the air pipe closely.
2.Adjust the air switch.
3.Insert the plug closely.
4.Remove sundries.
5 . Add water to the
suitable height.
1.Insert the plug closely.
2.Adjust the strength
adjusting.
3.Insert the air pipe
closely.
1.Change the seal ring.
2.Screw down the nut,
and seal the interface.
3.change the water tube.
1.Change the fuse with
specification.
2.Add water to be higher
than the nozzle.
3.Change the light bulb.