Operation Notes - TCL RP318BSE0 Bedienungsanleitung

Operation notes

Before reversing the door, please prepare the following tools: cross screw driver, wrench. Note:
please remove the main plug before reversing the door. Two people may be needed.
1.Close the door, take out the screw from the upper hinge cover with a cross screw driver, remove
the hinge cover, and then disassemble the connection terminal, screw off the top hinge, and take
down the door. Remove the screw cover on the left.
2.Take out the screws of the middle hinge with a cross screwdriver, remove the middle hinge,
remove the screw cover at the left screw hole, and take down the lower door.
3.Laying down the refrigerator, and remove the lower hinge and leveling angle at the bottom of the
refrigerator.
4.Remove the wire cover of the upper upper door cover, change the wiring harness from the right
side to the left side, install the wire cover of the upper end cover, and change the upper door and
lower door stop to the left side. (the replacement of upper door and lower door stop is the same as
that of lower door, and the lower left figure will be changed to right picture)
11