S-idee H100 Benutzerhandbuch Seite 31

fig.16
6.Disconnect the wire connector for motor and cabin, then take the motor seat out,
fig.6.
7.Hold the rubber part of main shaft, use spanner to release the nut at the end to
take the propeller out,fig.7.
8.Pull the main shaft to the left,fig.8.
9.Add lubrication oil to the tail of main shaft tube,fig.9.
10.Rotate the main shaft clockwise/anti-clockwise, and move forward/backward to
make sure the oil is evenly inside the tube,fig.10.
11.Hold the rubber part of main shaft, use spanner to tighten the nut at the end to
secure the propeller in position, i.e. the propeller with copper outside should
attach to the main shaft,fig.11.
12.Connect the wire connector for motor and cabin,fig.12.
13.Put the motor seat back in position, check if propeller runs smooth, then secure
it with screws, fig. 13.
14.Connect the plastic water hose to the cooling tube on the motor,fig.14.
15.Install the motor protection cover and fit it on seat with 2 screws,fig.15.
16.Connect the motor to battery wire,fig.16.
NB:
1.Battery wire exhaust to boat side,to prevent the wire were cut off by the steering wheel.
2.All plug need tightly.
3.Insure the cabin cover tightly,prevent leakage.
Pairing connection for the boat and remote controller
This boat must be on water to start the pairing. Place the boat on water.
Mode 1 - switch on the remote controller, a sound comes out, the red LED at left stays
on, the blue LED at right goes off once it lights up and the LCD displays MODE 1, then
the pairing succeeds.
Mode 2 – press either turn left or right trim button and switch the remote controller on
at the same time, a sound comes out, both red and blue LED stays on and the LCD
displays MODE 2, then the pairing succeeds.
The pairing will be disconnected if the boat is taken away from water. It always go to
default setting, MODE 1 when restart the controller.
WARNING
1.This R/C boat is designed for teens over 14 years of age. Should operate under adult
supervision.
2.Do not recharge the battery immediately after play. Must keep the battery cool down before
recharging.
3.The boat contains small parts, pay attention to choking hazardous.
4.Pay attention to the rotating propeller to avoid any injury.
5.The motor is hot after play, do not touch until it cools.
6.Regular check the boat, motor, circuit, battery for any damages, must repair completely before
next play.
7.When the ship sailing,insure the area without people.Cannot have aquatic or debris in the water,
avoid the propeller were caught or damage to the ship.
8.Do not pilot the boat more than 150m away from the remote control,otherwise connection will
be lost.
1.Disconnect the motor from the battery,fig.1.
2.Unscrew the motor protection cover,fig.2.
3.Pull the plastic water hose out from the cooling tube
on the motor,fig.3.
4.Unscrew the motor seat,fig.4.
5.Lift the end of motor up carefully, then disconnect the
motor from the main shaft,fig.5.
-6-