Technical Data; Charging Procedure - Kress KAC20 Bedienungsanleitung

TECHNICAL DATA

Charger voltage
Output voltage
Charging current
Power input
Charge battery
Charging time
2.0Ah
4.0Ah
6.0Ah
Protection class
Machine weight
For the technical data of the types, the number of cells
and the rated capacity of the batteries that can be
charged, please refer the nameplate of the battery pack
supplied by Kress.

CHARGING PROCEDURE

NOTE: Before using the tool, read the
instruction book carefully.
4
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
EN
WARNING: The charger and battery pack are
specifically designed to work together so do
not attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery pack
connections because an electrical failure and hazard
will occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must charge
once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger, the LIGHT
will become green and flash to show charging has
started.
3) After charging approx. 45 minutes, the light will
stay green without flashing, which means the
battery is full, and charging is completed.
WARNING:
When battery charge runs out after
continuous use or exposure to direct sunlight
or heat, allow time for the battery to cool down
before re-charging to achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems that
can arise with battery packs. Indicator lights indicate
problems (see table below). If this occurs, insert a new
battery pack to determine if the charger is OK. If the
100V-240V~50/60Hz
20V
2A
50W
Li-ion
approx. 58mins
approx. 125mins
approx. 180mins
/II
0.41kg
new battery charges correctly, then the original pack
is defective and should be returned to a service center
or recycling service center. If the new battery pack
displays the same problem as the original Battery Pack,
have the charger tested at an authorized service center.
Light ON flash
Red on
Red flash
----------
Green on
Green flash
----------
BATTERY TEMPERATURE PROTECTION
This charger has a battery temperature protection feature.
When the charger detects a battery pack that is too hot
or cold (the light will be red and flash), it automatically
activates the protection circuit, and suspends
charging until the battery pack has reached the correct
temperature. The charging process will then automatically
begin (the light will be green and flash). This feature
ensures maximum battery life.
DEFECTIVE BATTERY PACKS
This charger will detect a defective battery pack. When
a defective battery pack is inserted into the charger, the
charger will try to repair it. This process will last about
30mins (the light will be green and flash). If the repair is
successful, the charger will automatically begin to charge
the battery pack to the highest capacity possible (the light
will be green and flash). If the light becomes solid red, the
battery pack is dead.
NOTE: Repaired battery packs are still usable but should
not be expected to perform as much work as new battery
packs.
IMPORTANT CHARGING
NOTES:
1. For a new battery or a battery that has been in storage
for sometime, please recharge the battery before use.
If you want to store the battery for a long time, please
fully charge the battery pack to ensure maximum
battery life.
2. Longer life and better performance can be obtained if
the battery pack is charged when the air temperature
is between 18°Cand 24°C. Do not charge the battery
pack in air temperatures below 0°C, or above 40°C.
This is important as it can prevent serious damage to
the battery pack.
Status
Defective Battery
Battery Temperature
Protection
The temperature of bat-
tery pack is less than
0°C or more than 45°C.
Fully Charged
Charging