Leonard LKG1843 Benutzerinformation Seite 24

24 Leonard
Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
Possible cause
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
During the automatic de-
frosting process, frost
melts on the rear plate.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" .
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.