Regrinding Saw Chain; Storage; Disposal; Trouble Shooting - Zipper Maschinen ZI-KTS40V-AKKU Betriebsanleitung

14.2.2 Regrinding saw chain

Special tools are required to sharpen the saw chain and guarantee that the blades of the chain are
sharpened at the correct angle and to the correct depth. We recommend having the saw chain
reground by specialist.

14.3 Storage

 Store the machine in a dry and frost-free place (10-25 °C).
 Store the battery and the machine separately.
 Charge the battery before storing the machine in winter.
 For a prolonged period of non-use always drain the chain lubricating oil out the power tool.
 Place the protection hood on cutting mechanism.
 Keep the machine, in particular its plastic components, away from brake fluids, petrol, petroleum
products, penetrating oil, etc. They contain chemical substances which may damage, attack or
destroy the plastic components of the machine.
 Fertilisers and other garden chemicals contain substances which may have a highly corrosive effect
on the metal parts of the machine. Therefore do not store your machine near these substances.

14.4 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
15

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, UNPLUG THE BATTERY!
Trouble
Motor does not start
Unusual, loud noises and
excessive vibrations
Poor cutting result
Blades becomes hot
Battery cannot charged
anymore
Should you in necessary repairs not able to properly to perform or you have not
the prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KTS40V-AKKU
Possible cause
 Battery is not plugged in
 Battery is not charged
 Safety switch is damaged
 Power switch is damaged
 Loosen cutting tool
 Debris on the cutting tool
 Cutting tool damaged
 Blunt cutting tool
 Chain tension
 Low lubricant
 Contact failure
 Battery damaged
N O T I C E
TROUBLE SHOOTING
Solution
 Plug in battery
 Recharge battery
 Check safety switch
 Check safety switch
 Tighten cutting tool
 Remove derbies
 Change cutting tool
 Change cutting tool
 Check chain tension
 Oil the lubrication
 Check contact pins
 Change battery
34