After Use; Chain Brake - Zipper Maschinen ZI-KTS40V-AKKU Betriebsanleitung

Battery state of charge:
 Press the button on the battery to check the state
of charge at the state of charge indicator LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after the
button is pressed, the battery is faulty and must be
replaced.
 Check that all parts are firmly attached and obviously undamaged.
 Before using the chain saw, always check that the chain brake is in perfect working order.
 Check that there are no leaks.
 Never work on unstable ground!
 Never work while standing on a ladder!
 Do not bend too far forwards when working!
 Use the power tool only when the weather conditions and terrain are favourable!
 Stand with both legs firmly on the ground.
 Beware of obstructions in the working area.
 When working, always hold the power tool with both hands! Left hand on the hand grip and
right hand on the handle
 Switch the chain saw on before starting the cut.

After use:

Always switch the motor off before you put the power tool down! When the On/Off switch is
released, the saw chain continue running briefly.
 Stop the motor.
 Wait until all rotating parts have come to a standstill.
 Remove the battery.
 Place protection hood on cutting mechanism.
 Activate chain brake
 Leave power tool to cool down.

13.4.1 Chain brake

The chain saw features a safety chain brake which stops the chain within a fraction of a second in
the event of a kickback. If a kickback occurs, the chain brake is automatically actuated by touching
the hand guard with your left hand.
Activating:
 Tilt the hand guard a towards the saw rail tip.
Loosening:
 Pull the hand guard towards the handlebar.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KTS40V-AKKU
W O R K I N S T R U C T I O N S
OPERATION
32