Remaining Risk Factors; Rotating Parts - Zipper Maschinen ZI-KTS40V-AKKU Betriebsanleitung

 Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
 Use only original batteries with the voltage indicated on the rating plate of your electric power tool.
If other batteries are used, e.g. imitations, reconditioned batteries or third-party products, there is
a risk of injuries as well as damage caused by exploding batteries.
 The battery voltage must match the battery charging voltage of the battery charger. Otherwise
there is a risk of fire and explosion.
 Recharge only with the charger specified by the manufacturer. A charger that is suitable for one
type of battery pack may create a risk of fire when used with another battery pack.
 Pointed objects, such as nails or screwdrivers, or external forces may damage the battery. This
may cause an internal short-circuit and the battery to burn, smoke, explode or overheat. For
disposal, transport or storage, the battery must (plastic bag, box) or the contacts are packed must
be taped.

11.3 Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
 Risk of injury due to noise:
Working for a long time can damage your hearing if you do not have a very good hearing protection.
 Risk of injury due to the working area:
Solid objects, stones, metal parts, or the like can be thrown out!
 Risk to the hands or fingers:
Do not grab in the cutting tool while it is rotating.
 Risk of injury due to pick up and roll up:
Wires and cords can be detected by the cutting tool and can damage the machine and can cause
injuries. Unplug battery and safety switch (if equipped) before removing the deposits!
 Risk of injury due to vibration:
The declared vibration emission value has been for a standardized test is measured and can be used to
compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
 Rotating parts
Be rotating parts mounted incorrectly, this can lead to serious accidents.
Check before starting work, the cutting blade for tight fit
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KTS40V-AKKU
W A R N I N G
SAFETY
27