Operation; Inserting/Replacing The Battery; Switching Off - Zipper Maschinen ZI-KTS40V-AKKU Betriebsanleitung

Checking the chain lubrication:
 Start the machine.
 Hold running saw chain for some time approx. 15 cm above a suitable surface. If there is
adequate chain lubrication, the oil which is ejected by the saw chain will form a light trail.

13.4 Operation

Inserting/replacing the battery:

 Charging the battery as described in the user
manual of the charger.
 Press the charged battery into the power tool until
it clicks into place.
 To remove, press the release button (1.) and pull
out the battery (2.).
Switching on:
 Ensure that the chain brake is released before
starting the chain saw. To do this, pull the hand
guard back towards the handlebar.
 Press the release button and hold down (1.).
 Press the rear On/Off switch (2.). The saw chain
runs.
 Release the release button again.

Switching off:

 Release the On/Off switch.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KTS40V-AKKU
OPERATION
31