Angle Adjustment; Overheating Protection; Cleaning And Maintenance - Perel IH0003 Bedienungsanleitung

When the room has reached the desired temperature, turn the thermostat knob to the left until
the heater switches off. The temperature is now set and the heater will automatically switch
on/off to keep the temperature at a constant level.
Switch off and disconnect the heater after use.
When the appliance is switched off (with supply cord in socket), the fan will keep blowing until
the appliance is cooled down.
6.2

Angle Adjustment

Slightly loosen the adjustment knobs while holding the body with one hand. Tilt the body to the
desired angle and retighten the adjustment knobs.
6.3

Overheating Protection

This heater is equipped with an overheating protection, which will automatically switch off the
heater in case of overheating. If this occurs, please unplug from the mains and allow cooling
for 30 minutes before re-connecting and switching on again.
To avoid overheating, check that the appliance is sufficiently ventilated and that the air intakes
are unobstructed. Please contact your local dealer if the heater keeps switching off.
7.

Cleaning and Maintenance

Before cleaning, switch of the appliance, disconnect from the mains and allow to cool
completely.
Never immerse the appliance in water or any other liquid. Protect it from splashes and spraying
liquid.
Occasionally wipe with a damp cloth to keep it looking new. Do not use harsh chemicals,
cleaning solvents or strong detergents.
V. 02 – 15/06/2018
IH0003
6 ©Velleman nv