Battery Replacement - PeakTech 4250 Bedienungsanleitung

Application notes
1. In the case of DC current, the output is positive when the current
flows from the upside (marking "+" textured on the jaws) to the
underside of the clamp. The red banana plug is positive.
2. In the case of DC current measurement, a hysteresis effect can
occur so that it is impossible to zero the clamp properly. To
eliminate this effect, open and close the jaws several times and
push zero adjustment button.

5. Battery Replacement

Remove the screw on the back side, open the case and remove the
battery from the battery room, and replace with a 9 V battery (NEDA
1604 type)
Caution!
Batteries which are used up dispose duly. Used up batteries are
hazardous and must be given in the for this being supposed
collective container.
21