Operation; Cooling Function; Cleaning - Carrera 532 Bedienungsanleitung

04. OPERATION

WARNING! Make sure to select the right voltage.
The voltage switch must point to the relevant voltage at your
current location!
NOTE: Before using the appliance for the first time, switch it on for a
few minutes and allow it to run at the highest speed and temperature
setting. As a result of the manufacturing process, a slight odour may be
produced. This is not harmful and only occurs during initial use. Ensure
that the room has good ventilation.
Switching the appliance on/off and controlling the air flow
1. Insert the mains plug into an easily accessible socket.
2. The on/off switch and switch for the power settings 3 allow you to
switch the appliance on and to select the desired power setting:
0 – off
1 – slow air flow, lower temperature
2 – fast air flow, higher temperature
3. After drying, set the on/off switch to 0 (off) and pull out the mains
plug.
Ionic technology
This appliance features ionic technology, permanently releasing ions
onto the hair to reduce the static charge of the hair and allow easier
styling.

Cooling function

The hair section styled with hot air can be cooled to improve the dura-
bility of your hairstyle.
While drying your hair, slide the on/off switch to the "COOL SHOT"
● ●
position to obtain a cool air flow irrespective of the outlet temper-
ature (see fig. B).
If you no longer need the cool air flow, slide the on/off switch back.
● ●
24 GB
Styling nozzle
The styling nozzle makes it possible to target the air flow at specific
sections of hair.
Attach the styling nozzle to the front of the hair dryer so that it
● ●
clicks into place.
The styling nozzle can be rotated into any desired position.
● ●
You can remove the cooled styling nozzle from the hair dryer.
● ●

05. CLEANING

DANGER!
Before cleaning, pull out the mains plug and allow the
appliance to cool down.
CAUTION!
Do not use any harsh or abrasive cleaning agents.
Clean the appliance regularly. Be particularly sure to check that the air
inlet and air outlet are free from dust, hairs and fluff.
Wipe down the casing, the protective grille over the air inlet and
● ●
the styling nozzle with a slightly damp cloth.
Remove the styling nozzle from the hair dryer. Hold the hair dryer
● ●
with the air outlet facing 7 downwards. Clean the safety fins with
a brush.
Hold the hair dryer with the air inlet facing 1 downwards. Clean
● ●
the safety mesh with a brush. (see fig. D).
GB 25