MALTEC CARBON770W-PRO WiFi Bedienungsanleitung Seite 18

6. Heater will start working when the setting temperature is 1 degree higher than room
temperature, or stop working when the setting temperature is 1 degree lower than
room temperature.
7. Press
to increase one hour and with each press of
cycle as
The countdown timer is set after 5 seconds unchanged blinking, then display room
temperature.
II. Open Weekly mode 7*24hours
(Connect WIFI and APP to operate with smartphone)
Connecting to Wifi
1.To connect your heater to the WiFi, the first step is to download the TUYA Smart app
onto your smartphone.You can find the app by scanning the QR code below or searching
"TUYA Smart" in the Google Play or Apple appstore.
2. Download and install the app. Unless you already have a Smart Life account, you will
need to create an account by tapping Register.
3. The device will automatically determine your country, although you can change this if
necessary. Enter your phone number or email address. If you enter a phone number, a
verification number will be sent to your phone: enter this number to verify, then create a
password. If you enter your email address, you'll just need to create a password.
4.To add your heater to the app, first put the heater in WiFi connection mode.
Turn the main switch on, you will hear "beep", the full screen will be light on for 1.5
seconds , then display "--", WIFI light flashing and the heater is in standby mode;
You can connect WiFi and add the device in TUYA APP with smartphone.
5. If the WiFi icon is not flashing, press the "on/off" button back to the stand by mode .
Once the Wifi icon is flashing, go to the app and press Add a Device. Select the device
type (Small Appliances > Heater) and confirm that the indicator is flashing. You will then be
prompted to enter your WiFi password. This allows the app to find your heater using your
WiFi.
6.The app will then display its connecting screen.
NOTE: if the heater is failing to connect, long press "on/off" for 5 seconds. it will then
switch to its secondary connection mode. The heater has two connection modes: one
until the is light on to set the 0-24 hours timer, with each press of
to decrease one hour, it will be
18/34