Inhaltsverzeichnis
Werbung
time for appliance on.
♦ Press the ''▲'' / ''▼'' button once to increase or decrease the time setting by 1 minute.
♦ Press the button ''▲'' / ''▼'' for 2 seconds to increase/decrease the time setting by 10 minutes.
Note: If you don't set the time in 10 seconds after you press TIMER ON button, the remote controller will exit the TIMER ON
mode automatically.
2) When your desired time displayed on LCD, press the TIMER ON button and confirm it, a beep can be heard and then the
TIMER indicator "ON" the indoor unit stops flashing.
3) After the set timer displayed, the clock will be displayed on the LCD of the remote controller instead of set timer.
- How to cancel TIMER ON
Press the TIMER ON button again, a "beep" can be heard and the indicator disappears, the TIMER ON mode has been
cancelled.
Note: It is similar to set TIMER OFF; you can make the appliance switch off automatically at your desired time.
● TURBO MODE SETTING:
♦ TURBO mode is used to start or stop fast cooling and heating at high fan speed.
♦ In Turbo mode, you can set airflow direction or timer. If you want to exit from TURBO mode, press any - TURBO, MODE,
FAN or
button, the display will return to the original mode.
● LIGHT FUNCTION
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If the light is turned
on, is displayed. If the light is turned off,
● X-FAN FUNCTION
Pressing X-FAN button in COOL or DRY mode, the icon
minutes in order to dry the indoor unit even though you have turned off the unit.
After electrification, X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
● LOCK FUNCTION
Press the ''▲'' and ''▼'' buttons at the same time to block the last setting operation by the remote controller.
All the buttons disabled, including the
● °C / °F FUNCTION
Press the ''MODE'' and ''▼'' buttons at the same time with the unit off to choose the display of temperature in °C and °F.
● ENERGY-SAVING FUNCTION
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays ''SE''. Repeat the operation to quit the function.
● 8°C HEATING FUNCTION
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start 8°C Heating Function Nixie tube on the remote
controller displays
and a selected temperature of ''8°C''.
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
4.5. Manual operation
Manual operation can be used temporarily in case you cannot find the remote controller or its batteries are exhausted.
Manual switch
disappears.
button. Press the ''▲'' and ''▼'' buttons again to enable the buttons functions.
1. Open and lift the front panel up to an angle until it remains fixed with a clicking sound.
2. One press of the manual control button will lead to the forced AUTO operation.
3. Close the panel firmly to its original position.
CAUTION:
● Once you push the manual button, the operation mode will be selected according to
the room temperature as: COOL, HEAT, FAN.
● Press the button to stop the operation of the air conditioner.
is displayed and the indoor fan will continue operation for 10
6
Werbung
Inhaltsverzeichnis
