Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.7 ECO / FULL ECO;
ECO:
In the ECO mode, the baby-unit is switched off while the baby is sleeping.
However, in the background the baby-unit regularly checks the connection
between the parent unit and baby unit. You'll be notified if the connection is
lost.
FULL ECO:
In the FULL ECO mode, the baby-unit is also switched off while the baby is
sleeping and even the connection check is disabled. This means absolutely
no radiation when the baby is sleeping.
The baby unit activates as soon as the baby wakes up and starts making
noises.
Attention: keep in mind that in the FULL ECO mode, there's no link-
check and therefore no alert tone when the connection between the
parent unit and baby unit is lost.
To set the ULL ECO mode on or off:
1. tap 3x button M OF THE BABY-UNIT
2. use the
and
button to switch between ON (FULL ECO activated)
and OFF (FULL ECO disabled)
3. briefly press the
button to confirm you selection and to leave the
menu
To check the link in between:
In the ECO or FULL-ECO mode you may briefly press the TALK button in the
meantime to enable the sound (provided the volume is not set to 0) for about
10 seconds.
6
EXPANSION/NAME ASSIGNMENT
The DBX-68 is capable of registering up to 4 baby units. This way you
can monitor 4 babies and because you can assign an individual name to
each unit, you can directly determine which child is crying. Additionally,
for each baby unit you can set the talk-back function, feeding timer, room
temperature, lullabies and night light.
6.1 TO REGISTER & ASSIGN A NAME:
Attention: only during registration a name can be assigned to the
baby unit. If the baby unit is already registered and you only need
to adjust or set the name, you'll only be able to this this by following the
registration process again.
When you're only expanding your setup, ALL baby units must be registered
(again), i.e. also the baby units that were previously registered. However,
the names of baby units previously registered will remain in the memory.
preparation:
1. switch off the parent unit and the/all baby unit(s) by briefly pressing and
holding the
button until the display is completely empty
parent unit:
2. press and hold the TALK button on the rear of the parent unit
3. now press and hold the
parent unit turns on and P/PAIRING appears in the display with the P
flashing. Now release both buttons
first baby unit:
4. press and hold the
button until first the baby unit switches on after
approx. 3 seconds and then 'P' starts flashing in the display after
another 2 seconds or more, now release the
5. use the
and
buttons to select the respective baby unit (select 'baby-
1' for the first baby unit, 'BABY-2' for the second unit, etc.) and press
6. use the
and
buttons to select the first letter of the name and tap the
M button
7. repeat this for all of the following letters ('space' is located directly after
the 'ABC', followed by the numbers 1 through 9. The name may consist
of a maximum of 8 characters)
46
button for approximately 3 seconds until the
button
Werbung
Inhaltsverzeichnis
