Werbung
Fig. 11
Assembling and installing the fan
11. Install light bulbs (Max.E27 60W, not supplied) to the lampholders. Switch the power on to check the operation of the light kit and fan.
Refer Fig 10.
WARNING! Power o before changing the bulb.
12. Install the glass shade onto the switch housing by tightening the three thumb screws. Refer Fig. 11.
CAUTION: Do not use pliers to tighten the thumbscrews. Over tightening of the thumb screws may crack the glass shade and cause
dangers. Refer Fig. 11.
Note: The use of electric drivers can overtighten the screws and damage threads, DO NOT use power tools for tightening screws.
Fig. 13
Reverse Function
Your ceiling fan can operate either in fan mode or reverse fan mode. To switch between modes, switch the switch located on the motor
assembly. Refer Fig. 13.
Summer (Forward)
Winter (Reverse)
During the winter, your fan should run in a clockwise direction at low speed. This will gently draw the warmer air down from the ceiling ,
balancing the rooms temperature, and allowing
you to lower your heating thermostat.
mark "bulb is not included"?
Fig. 12
Werbung
