Garmin TACX NEO BIKE PLUS Schnellstartanleitung Seite 6

Installing the Legs on the Trainer
You must have the assembly kit
A
assemble the Tacx NEO Bike Plus trainer. Use care when lifting the trainer.
1 Place the trainer on the floor, and tilt it back to install the front legs
2 Open the assembly kit
3 Use the M10 x 90 mm bolt
install the front legs.
4 Tilt the trainer forward to install the back legs
5 Use the M10 x 65 mm bolts
6 Turn the knobs on the front legs to stabilize and level the trainer (optional).
6
for this task. You must have at least two people to
.
, M10 x 130 mm bolt
.
, 10 mm washers , and the 8 mm hex key to install the back legs.
, 10 mm washers , and the 8 mm hex key to
.
Quick Start Manual