Garmin TACX NEO BIKE PLUS Schnellstartanleitung Seite 4

Adjusting the Trainer Geometry
Before you assemble the Tacx NEO Bike Plus trainer, consider that the saddle and handlebars have set
screws installed from the factory that can be adjusted and tightened using a hex key. To install the 4
handles as shown in this manual, you must remove the 4 set screws using a hex key.
NOTE: If multiple riders will use trainer, Tacx recommends installing the handles for easy adjustments.
The handles are packaged in the assembly kit with the screws and washers. If you are the only rider that
will use the trainer and you do not make geometry or posture adjustments, you can use the set screws
and a hex key.
• Get off the trainer before adjusting the saddle or handlebars.
• Match the geometry of the trainer to your road bike.
TIP: For instructions on how to measure your road bike, see the owner's manual.
• If you adjust your saddle more than 1 cm, check the saddle height and the handle bar reach again.
• Do not exceed the maximum range of the saddle or handlebars.
• If you change your pedals or saddle, check the geometry of the trainer again.
After you tighten each handle, align the handle to be parallel to the frame or rail. Pull out and twist the
handle.
4 Quick Start Manual