Wiring Instructions - Ecco EW2031R Installations- Und Bedienungsanleitung

Installation:
For best results, select a mounting location between approximately
72" to 96"[1829 mm to 2438mm] from the ground. Once mounted,
angle the lighthead so the boundary line appears in the desired
location as shown in FIGURE 1.
1. Select a mounting location for the unit on a flat surface, and drill
a through hole (see below).
EW2015R, EW2025R, EW2030: 5/16" hole
EW2031R: 11/32" hole
2. Secure the light head with the supplied hardware.
3. Adjust the unit to face downward as shown and tighten the
screws located on each side of the worklamp.

Wiring Instructions:

Black Wire: Connect to (-) ground
Red Wire: Connect to a dedicated (+) power source with a customer
supplied inline fuse.
See wiring diagram in Figure 2 for details.
VEHICLE BODY
LENS
(+)
IMAGE SHOWN:
EW2015R WIRING
APPLIES TO EW2015R,
EW2025R & EW2030R
FIGURE 2
RED BLACK
GROUND
(-)
GROUND
VEHICLE BODY
LENS
(+)
IMAGE SHOWN:
EW2031R
FIGURE 3
FIGURE 1
RED
GROUND
(-)
GROUND
BLACK
Page 2 of 3