Klarstein Reinraum 2G 10030359 Bedienungsanleitung Seite 23

Warning: Danger of fire
Instructions. Reminder: Remove plug from power supply before opening unit. DO NOT vacuum sol-
vents, explosives, inflammable and/or hazardous liquids such as petrol, oil, spirits, paint, thinners,
acids etc.
1. Ensure the machine is unplugged from the power supply.
2. Fit the foam filter.
3. Reposition the head onto the tank body and clip in place.
4. Ensure that the shampoo solution has been mixed with the recommended proportion of water and pour
it into the shampoo tank. Insert the shampoo tank connecting tube and filter into the tank and push the
cap onto the tank filler neck to avoid any shampoo splashing out whilst working.
5. Plug the nozzle on the other end of the shampoo tank connecting tube into the shampoo inlet hole on
the rear of the motor housing.
6. Ensure that the transparent shampoo delivery tube is fitted correctly around the suction hose and held
in place with the clips provided.
7. Screw the large threaded connector on the end of the flexible suction hose to the vacuum inlet on the
front of the tank.
8. Push the connector on the end of the shampoo delivery tube into the shampoo outlet nozzle on the
front of the motor housing.
9. Slide the spraying trigger fitting into the mount at the top of the plastic tube. Push gently and ensure it
clicks into place.
Fit the large washing head to the plastic tube. Connect the shampoo delivery tube from the head to the
trigger. The black fitting is a push and twist fit.
10. The spraying nozzle at the other end of the delivery tube is a push fit into the mounting on the underside
of the head. There is a notch in the nozzle which must fit onto a spigot in the head mounting to ensure
that the nozzle outlet is the right way round.
11. Select the switch to position "I", to operate wet and dry vacuuming function. Select the switch to position
"II", for simultaneous shampoo application and dirty liquid suction.
12. Squeeze the trigger to apply shampoo to the area to be washed.
Carpet cleaning
Vacuum the carpet thoroughly before washing it. For best results we recommend you first remove all furni-
ture from the room to be cleaned, or move it away from the cleaning area.
1. Start furthest away from the doorway to the room, extend the hose and work backwards.
2. Switch to position , and squeeze the trigger to spray shampoo into the area to be cleaned.
3. Squeeze the trigger as you pull the head back towards you, in lengths of approximately 1.5m.
4. Refill the tank if the fluid spray stops. Switch off and return to where you started.
5. Switch to position to suck up the dirty solution and repeat the previous pattern of strokes. Apply
more shampoo in any particularly dirty area. The dirty solution is visible as it is sucked up through the
transparent head. Stop vacuuming when there is no more dirty fluid visible.
6. Do not walk over any newly cleaned area until it is completely dry.
23