Philips SBCRP520/00 Bedienungsanleitung Seite 5

Instructions for use
All manuals and user guides at all-guides.com
N
O T E
It is possible to program modifications in the Teletext, PIP and
coloured buttons sets in any given combination simultaneously.
Remote control is not working at all
Cause: Your TV is purchased after 1999 and uses the new RC-6
remote control protocol.
Solution: Press and hold the OK button and digit 5 button
simultaneously for 5 seconds.
- Commands are sent in the new protocol. Some
buttons obtain a different function. See 'LIST OF
FUNCTIONS (in RC-6 mode)' .
N
O T E
It is not possible to program modifications in the Teletext, PIP
and coloured buttons sets when your remote control is
operating in RC-6 mode.
Reset modified buttons set to default function
If you want to reset any of the modified Teletext, PIP or
coloured buttons sets to their default function:
1
Press and hold the OK button.
2
Simultaneously press for 5 seconds the same digit button
you used to:
- modify a set of Teletext, PIP or coloured buttons,
- switch your remote control to RC-6 operation mode.
Adding functions
N
O T E
You can program the additional TV and VCR functions listed
below.
Buttons A, B, C, D or E are reserved for additional functions
you assign yourself. To program a button:
1
Press and hold the button (A, B, C, D or E).
2
Enter the 3-digit code of the required function listed
below.
3
Release the button.
If the TV function you require is not listed, please call our
Helpline to obtain the correct code.
It is not possible to add other VCR functions then listed
below.
N
O T E
- If a wrong code is entered the button will maintain its initial
function.
- By adding a new function you delete the original secondary
function of the button. To reset the original function see
'Resetting all functions' .
5