The Remote Control System; Transmitter - XciteRC Flybar 290E easy Single Blade 2.4 GHz Bedienungsanleitung

The remote control system

Here you get an overview of the remote control system of your XciteRC Flybar 290E and its various features
and settings. Before the first flight, you should absolutely have read and understood all these functions and
EN
settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter. Remove the srew and slide
the cover down (1). Insert six AA batteries into the battery compartment of the transmitter (2). Pay atten-
tion to the correct polarity!
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch.
• After a few seconds the POWER LED will light constantly.
does not light at all, the model may not started – crash hazard! Change transmitter batteries immediately.
• WARNING: check the POWER LED also during operation. If the POWER LED starts to blink, stop
operation, switch the model off and replace the transmitter batteries – crash hazard!
• ATTENTION: The maximum range of the remote control system is about 50 meters, do not fly
farther away under any circumstances! If the XciteRC Flybar 290E gets out of range, the fail-safe function
is activated and turns off the motor.
Mode 2 (Gas links)

Transmitter

Antenna
Throttle-LED
Balance
Throttle stick
yaw
Yaw trim
Throttle trim
16
Backside
Power-LED
Mode switch
Mode LED
Control lever
(forward-back, roll)
Forward-back trim
Roll trim
ON/OFF switch
Display
The remote control system
Battery-
compartment
cover
6x 1.5 V AA
batteries
WARNING: if the POWER LED flashes or
Mode 1 (Gas rechts
Antenne
Gas-LED
Balance
Steuerhebel
(vor-zurück, gieren)
Trimmung vor-zurück
Trimmung gieren
XciteRC Flybar 290E Easy