Setting Up And Operating The Projector; Inserting/Changing The Projection Motif - ORGATEX eox Spot 20 Nutzungsinformation

5. Se�ng up and opera�ng the projector
WARNING! Risk of burns!
You can burn yourself on projector parts which have become hot.
▶ Let the device cool for at least 10 minutes before any set-up work.
WARNING! Optical radiation hazard!
Optical radiation can cause temporary or permanent eye damage.
▶ Never stare directly into the beam of light.
ATTENTION! Possible damage when setting up the projector!
Do not tilt the projection head when the locking screw is tightened.
▶ Loosen the locking screw before tilting the projection head.
Some of the steps below require the projector to be switched on. Optical radiation can cause high temperatures
at close range and may be dangerous for your eyes. Exercise appropriate caution. Only switch on the projector
once the gobo has been inserted. Carry out set-up work as soon as possible after switching on the device.
A few settings still need to be made to the projector head
in order to set up your projection.
• Unscrew the two fastening screws and carefully re‐
move the shell from the projection head.
5.1. Inserting/changing the
projection motif
1. Loosen the locking screw.
2. Remove the gobo holder.
24
Settings
Orgatex