Bevel Cutting - Felisatti JS100/18L Originalbetriebsanleitung

6. Orbital motion
The blade of the saw cuts in an orbital motion. This feature is adjustable and provides faster,
more efficient cutting. The blade cuts through your work on the upstroke, but does not drag
across your work on the down stroke. The higher settings should be used when fast cutting
in soft material is desired. The lower settings should with more resistance.
7. Sawdust removal

8. Bevel cutting

1. Using the hex key provid-ed, loosen the base pivot screw until the base can be moved.
2. Slide the base forward until the base pivot screw can move freely in the slots in base.
3. Align the mark corresponding to the desired angle on the base with the edge of the
motor housing.
4. Securely tighten the base pivot screw.
5. Return hex key to the storage structure.
16
Orbital Control Lever
Blower Lever
The saw has a blower feature.
Turn the blower lever to the "O"
position to blow away dust and
clips from the immediate work
space to help keep the cutting
area clear.
Bevel-cutting angles may be adjusted
from 0° to 45° right or left. Angles for cuts
from 0° to 45° in 15° increments are
marked on a scale on both the left and
the right sides of the base. Notches on
the rear of the base provide positive
stops at each of the marked 15°
increments. Use of a pro-tractor is
recommended when accurate cuts are
required.