Setting The Angular Position Of The Machine Head; Setting The Fences; Setting Cutting Depth / Cutting Depth Limiting - Zipper Maschinen ZI-KGS210DS Betriebsanleitung

15.2.2

Setting the angular position of the machine head

15.2.3

Setting the fences

Front view
Back side
15.2.4

Setting cutting depth / cutting depth limiting

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
• Release the locking lever (1) and tilt the machine
head to the left or right with the handle (2) until the
desired angle is achieved.
NOTE: To swivel the machine head to the right side
•
(R), proceed as follows:
o Tilt the machine head approx. 10° to the left.
o Press the locking button (6)
o Then swivel the machine head over the 0° line to
the right.
o Now you can release the locking button (6)
again.
• The pointer (3) indicates the angle of inclination on
the scale (4).
• After the desired angle is set, fix the machine head
with the locking lever (1).
• To ensure that the machine is standing securely,
adjust the tilt lock (5) by turning it so that the
machine is stable.
• The two adjustable fences (1 and 2) must be adjusted
after changing the machine head angle.
• To do this, loosen the fixing screws (3a and 3a) and adjust
the fences so that there is a gap of max. 8 mm between
the saw blade and fence.
• Then retighten the fixing screws (3a and 3a) to fix the
fences (1 and 2).
NOTE:
• For a machine head angle of O°-45° to the right,
the removable fence (2) must be removed. In this case,
the maximum permissible workpiece height is also
reduced (see technical data).
• Loosen the fixing screw (3b) sufficiently to be able to take
off the removable fence (2) upwards.
• After finishing the cut, the removable fence (2) must be
refitted.
C AU TI O N
Before cutting, check that the fences and the
saw blade cannot collide (simulated cut with
switch-off machine).
• The cutting depth can be adjusted continuously by
turning the screw (1).
• To do this, loosen the knurled nut (2) on the screw (1).
• Turn the screw (1) on or off to set the desired cutting
depth. Then retighten the knurled nut (2).
Check the setting by performing a test cut.
OPERATION
N O TE
39
ZI-KGS210DS