Viesta VDE6065SR Gebrauchsanleitung Seite 11

3. If there is gap between the wall and the cooker hood, you may install the L-shaped bracket on the bottom of
the hood by 2 pcs screws (ST3 x 12mm). Note: The installation of the L-shaped bracket is optional.
WARNING
● For safety reason, please use only the same size of fixing or mounting screw which are
recommended in this instruction manual.
● Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
● Keep exhaust duct short and straight and do not reduce the size or restrict exhaust duct
● When using flexible duct always install the duct pulled taut to minimize pressure loss
● Failure to observe these basic instructions will reduce the performance and increase noise levels of the cooker hood.
● Any installation work must be carried out by a qualified electrician or competent person.
● Do not connect the ducting system of the hood to any existing ventilation system which is being used for any other
appliance ,such as warmer tube, gas tube, hot wind tube.
● The angle of the bend of the ventilation pipe should not be less than 120º; you must direct the pipe horizontally, or,
alternatively, the pipe should go up from the initial point and should be led to an outer wall.
● After the installation, make sure that the cooker hood is level to avoid grease collection at on end.
[ EN ● 11 ]
Version: 3:0
KEN002DH 24.02.2021
pic 3