Use; Ac Current Measurement; Ac Voltage Measurement; Resistance Measurement - Multimetrix CM604 Bedienungsanleitung

4.1. AC CURRENT MEASUREMENT

WARNING: Ensure that the test leads are disconnected from the clamp meter before making current
clamp measurements.
„ Set the rotary switch on 40A or 400A.
„ If the range of the measured is not known, select the higher range first then move to the lower range
if necessary.
„ Press the trigger to open jaw, fully enclose one conductor to be measured.
„ The clamp meter LCD will display the reading.

4.2. AC VOLTAGE MEASUREMENT

WARNING: Observe all safety precautions when working on live voltages.
„ Set the rotatory switch to the VAC or VDC position.
„ Insert the black test lead banana plug into the negative COM terminal; Insert the red test lead banana
plug into the + terminal.
„ Connect the test leads to the circuit under test.
„ Read the voltage on the LCD display.
„ If the rotatory switch is on the VAC position, press the MODE button to indicate Hz.
„ Read the frequency in the display.

4.3. RESISTANCE MEASUREMENT

WARNING: Never test resistance on a live circuit.
„ Set the rotary switch to the
„ Press the MODE button until the Ω symbol appears on the LCD display.
„ Insert the black test lead banana plug into the negative COM terminal. Insert the red test lead banana
plug into the + terminal.
„ Touch the test lead probes to the component under test, if the component is installed in a circuit, it is
best to disconnect one side before testing to eliminate interference with other devices.
„ Read the resistance in on the LCD display.

4.4. DIODE TEST

WARNING: Never test resistance on a live circuit.
„ Set the rotary switch to the
„ Press the MODE button until the
„ Insert the black test lead banana plug into the negative COM terminal; Insert the red test lead banana

4. USE

position.
position.
symbol appears on the LCD display.
16