Mounting Instructions - Suzuki 990D0-31J20-000 Anbauanleitung

Description: Sidestand Extension Plate
Fit: DL1000A L4-
No. Description
Part List
1. Extension Plate
2. Clamp Bracket
3. M5 x 12 DIN 965 Countersunk Screw
4. Protection Strip
5. Bank Sensor (43576-48B10-000)
6. Mounting Instructions (without picture)
Description
Tools
A Ratchet with short Extension
Required
B Torx Socket T-20
C Socket 10 mm
D Torque Wrench
E Liquid thread locker (without picture)
Please read this manual and follow its instructions carefully. To emphasize
IMPORTANT
special information, the symbol
NOTICE and NOTE have special meanings. These special meanings apply
except when laws or regulations require that the signal words be used with a
different meaning. Pay special attention to the messages highlighted by these
signal words.
Indicates a potential hazard that could result in death or serious injury.
Indicates a potential hazard that could result in minor or moderate injury.
Indicates a potential hazard that could result in vehicle or equipment damage.
NOTE: indicates special information to make maintenance easier or instruc-
tions clearer.
2

MOUNTING INSTRUCTIONS

Item: 990D0-31J20-000
Assembly Time: 10 Min.
Qty.
1
1
1
3
2
1
1
3
1
4
5
A
B
C
D
and the words WARNING, CAUTION,
!
WARNING
!
CAUTION
!
NOTICE
1.- Park the vehicle on a firm and even surface.
Preparation
2.- Turn off the vehicle and remove the ignition key. If necessary, allow the
engine/exhaust to cool prior to installation.
3.- Read these intructions carefully before assembly and examine whether all
parts are enclosed in accordance with the parts list.
4.- In order to avoid loosening of screws by vibration, we recommend securing
the threads with liquid thread-locker.
If you do not feel technical qualified to install this product on your own, please
consult with your nearest SUZUKI dealer.
1.- Attach the extensions plate (1) to the sidestand, as shown in drawing I.
Mounting
Use liquid thread locker to secure the screws (3), then tighten the screws.
Pay attention to the recommended torque of screws (3) (M5): 5,5 Nm.
2.- Replace bank sensor of the left footrest with bank sensor (5), as shown in
drawing II. Tighten the bank sensor (5).
Pay attention to the recommended torque of the bank sensor (5): 18 Nm.
Due to mounted SUZUKI Genuine Accessories the service and maintanance
Inspection
flat rate might be affected. Dismounting / Mounting of SUZUKI Genuine
Accessories is possibly necessary for service and maintenance.
The holder of the vehicle should always be in possession of the mounting
instructions.
Attachments can loosen from vibrations. Examine the screw tightness in
regular intervals in agreement with the service manual.
CAUTION
!
CAUTION
!
CAUTION
!
11/2013
SUZUKI GENUINE ACCESSORIES