I N S T A L L A T I O N I N S T R U C T I O N S
Description :
GLOVE BOX COVER , ALUMINIUM OPTIC Part Number :
BURGMAN UH 125/200 K7-
Applications :
Contents
Ref.
Description
Glove box cover, aluminium optic
①
Installation instructions
②
③
Caution label
①
Tools
Ref.
Description
Required
(1)
Neutral detergent
(2)
Shop towel
Important
/ CAUTION /
WARNING
Please read this manual and follow its instructions carefully. To emphasize
special information, the symbol
and NOTE have special meanings. Pay special attention to the messages
highlighted by these signal words
Indicates potential hazard that could result in death or injury.
Indicates potential hazard that could result in vehicle damage.
NOTE:
Indicates special information to make maintenance easier or
instructions clearer.
Preparations
1. Check that the kit includes all the parts listed in the first page.
2. Check each part in the kit for scratches or any form of damage.
before
3. Park the motorcycle on a level ground.
Installation
4. Remove the ignition key from the switch and store it in a safe place.
5. If you feel difficult to install this product on your own after reading the
instructions, please consult with your nearest SUZUKI dealer.
990D0-03H05-ALU
10min.
Installation time :
QTY
②
③
Installation instructions
(1)
(2)
NOTE
and words WARNING,CAUTION
▲WARNING
CAUTION
1/2
Installation
1
1
2
Glove box Cover ①
Shop Towel
Glovebox Cover ①
(1)
Set the Glovebox Cover ① on the motorcycle
body to check correct positioning.
Clean the attaching face on the motorcycle
(2)
body with the shop towel containing some
neutral detergent.
Thoroughly wipe off the detergent with wet
shop towel.
Dry the surface completely.
Peel off the entire release paper of the double-
(3)
sided adhesive tape on the back of the
Glovebox Cover ①
Press-fit the Glovebox Cover ① at the position
checked in (1) with soft shop towel.
Leave the attached cover as it is for 24 hours
after adhesion.
Please learn STD and attached caution label ③
on the same possition
2/2