Design & Dimensions Of Bwp 270 0A/ Bwp 270 1A; Control Panel - Weider BWP 270 1A Installations- Und Bedienungsanleitung

DESIGN & DIMENSIONS OF BWP 270 0A/ BWP 270 1A:
1.
Air outlet
2. Evaporator
3. Compressor
4. Air inlet
5. Enamelled container
6. Pocket for sensor - thermometer
7. Anode
8. Supplementary heating
9. Pocket for sensor – working phial
10. Anode*
11. Adjustable feet
12. Cold water inlet
13. Safety condenser
14. Foam

CONTROL PANEL

29. Operating-/alarm lamp heat pump
30. Operating-/alarm lamp supplementary
heating
31. Control panel (display)
32. Control button push/rotary
NOTE: The temperature in the tank must not exceed 65°C. This must be ensured by a safety device controlled by the
maximum DHW temperature in the tank (1
might damage the heat pump's refrigerant circuit and is not covered by the product warranty.
15. Heating coil (lower)*
16. Heating coil – inlet (lower)*
17. Heating coil – outlet (lower)*
18. Circulation connection
19. Hot water outlet
20. Defrost water outlet
21. Fan
*
Only BWP 270 1A
st priority) and a temperature limiter on the inflow side. Overheating the tank
ø707
1
4
8