Atag GVW360XL/P01 Bedienungsanleitung Seite 76

Table continued from last page
Problem
The dishwasher does not start.
The dishes are not clean.
Possible causes
The Start/Stop start button has
been pressed for too short a
time.
The door is not properly closed.
You have opened the dishwash-
er to add more dishes while a
program is in progress.
The door lock has not clicked
into place and locked.
A fuse/circuit breaker has been
tripped.
The plug is not plugged into the
wall socket.
The water tap is turned off.
Overflow/leaks.
A whirring sound (the drainage
pump) is heard from the dish-
washer and does not stop when
the main power switch is turned
off.
Check that the Delayed Start
option has not been selected.
The spray arms do not rotate.
Spray arm holes or bearings
blocked.
Action
Press and hold the left
navigation button and the Auto
Open option button until the
display starts flashing. Wait until
it stops flashing (60 seconds).
Close the door. Check that the
door lock clicks into place and
locks.
Press and hold Start/Stop until
the display shows "Program
started, close door".
Check.
Close the door and wait. After
a while, the dishwasher contin-
ues the program.
Check the door lock. If it has
not clicked into place and
locked, open the door.
Press and hold the left
navigation button and the Auto
Open option button until the
display starts flashing. Wait until
it stops flashing (60 seconds).
Close the door. Check that the
door lock clicks into place and
locks.
Check.
Check.
Check.
Check.
Turn off the water tap. Pull out
the plug and call the service
department.
Press and hold Start/Stop for
three seconds if you want to
cancel the Delayed Start option.
Check that the dishes are not
blocking the spray arms.
Clean the spray arms. See the
chapter Care and cleaning.
33