Oxford OF772 Hot Grips Montageanleitung Und Bedienungsanleitung Seite 7

J: Technical Data
• 12 Volt Systems only (Typical running voltage between 13.5 and 14.3 Volts)
• Switch information: High/Low settings
• Back drain current: Zero if the switch is turned OFF
• Current drain: Average 3.0amps per pair (42 Watts)
• Fuse: 5Amp mini-blade fuse (available in all automotive shops)
• When Hotgrips are fitted to your motorbike we always advise you to connect the battery to a
charging system such as the OXFORD Oximiser or Maximiser3800 when the bike is not in use.
On some motorbikes that have older or small capacity batteries, the extra electrical current
demanded by the Hotgrips can reduce the battery voltage levels and replacing this by charging
is recommended.
Oxford Scooter HotGrips Instructions 10/12
7