Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Clutch side HotGrips:
• Apply plenty of glue along the length and around the diameter of the handle bar where the grip
will finally sit.
• Push the grip into place ensuring that the HotGrips are positioned correctly so it does not foul the
clutch operation.
4. Throttle side HotGrips:
• If the grip is a very tight fit over the throttle slider, then it is advisable to apply plenty of glue on
the actual nylon throttle slider on the inner most flange and less along the length of the throttle
slider. This is to ensure that the grip and glue do not set too early and half way up the throttle
slider. We would also recommend to apply a ring of glue around the outer end of the throttle slider
as some of this will naturally be drawn up the length of the throttle slider tube.
If however the grip slides easily over the throttle slider then we would recommend using plenty
of glue around the whole circumference of the throttle slider to ensure a safe and secure fitment.
5.
Be sure to act immediately to wipe away any excess glue with a dry cloth.
6.
Allow the glue to dry for at least 24 hours before using. Ensure that the grips are firmly fixed in place
before use. Do not use if the grip moves and seek advice immediately.
H: Wiring Harness Installation
1. Find a suitable location to panel mount the switch and then take the wiring back to the battery to
ensure it easily reaches. Then unscrew the panel before drilling a hole of approximately 20mm.
In this kit, we provide a 20mm drill bit for making the hole. It will form a hole in most plastic panels.
When drilling, choose a slow drill speed and slowly create the hole. Remember to wear appropriate
safety goggles and clothing.
If you prefer, most motorcycle dealers will be happy to fit these Hotgrips for you.
Put the whole wiring loom through the 20mm hole and feed the wiring along the scooter chassis until
the ring leads reach the battery. Push the switch into the hole and ensure it has popped into position
and is retained securely in the panel. Ensure that the waterproof switch cover is wrapped under the
switch and is therefore sealing against the body panel.
2. Remember to install the switch in a suitable position ensuring the wiring harness will reach the wires
from the grips without strain.
3. The loom is designed for ease of fitting. There are only 2 wires that need attaching to the scooter's
existing wiring system. All other connections are through the multi pin block connectors and cannot
be fitted the wrong way.
4. A panel mount LED has been included in the wiring loom which can be fitted near to the switch if
required. To fit this, drill a 6.5 mm diameter hole and push the LED light from the inside of the panel
and it will pop into place.
Oxford Scooter HotGrips Instructions 10/12
5
Werbung
