Bosch GDE 18V-16 Professional Originalbetriebsanleitung Seite 8

8 | English
Intended Use
The dust extraction attachment is intended for collecting
drilling dust during drilling in concrete, brick, stone, ceramic
and tiles. The dust extraction attachment must not be used
when drilling in wood, metal or plastic.
The dust extraction attachment may be used only with the
following rotary hammers:
– GBH 18V-24 C
– GBH 187-LI
– GBH 18V-26
– GBH 18V-26 F
– GBH 18V-28 C
– GBH 18V-28 CF
Product Features
The numbering of the product features refers to the illustra-
tion of the dust extraction attachment on the graphics page.
(1) Dust cap for SDS plus quick-change chuck
(2) Dust cap for SDS plus fixed chuck
(3) Button for drilling depth adjustment
(4) Guide with depth stop scale
(5) Button for drill bit length adjustment
(6) Release button for dust box
(7) Viewing window
(8) Release button for dust extraction attachment
(9) Housing guide
(10) Contacts
(11) Guide groove
(12) Locking button
(13) Dust box
a) a)
(14) HEPA filter
a) The HEPA filter removes 99.97% of all particles larger than
0.3 micrometres.
Technical Data
Dust extraction attachment
Article number
Drilling diameter
Max. drill bit length
Max. drilling depth
Weight according to EPTA-
Procedure 01:2014
Values can vary depending upon the product and are subject to ap-
plication and environmental conditions. For further information
www.bosch-professional.com/wac.
1 609 92A 8R7 | (14.07.2023)
Assembly
Fitting the Dust Extraction Attachment (see
figure A)
– Put the guide groove (11) of the rotary hammer on the
housing guide (9) of the dust extraction attachment and
slide the dust extraction attachment onto the rotary ham-
mer. The dust extraction attachment must audibly en-
gage.
– To disconnect the attachment, press and hold the release
button (8) and pull the dust extraction attachment off the
rotary hammer.
Operation
Working advice
Never use the dust extraction attachment without a
u
filter. If the dust extraction attachment is used without a
filter, larger particles of drilling dust can be flung towards
the user and the power tool can be damaged.
Do not use damaged filters (e.g. no cracks, small
u
holes, etc.). Replace any damaged filters immedi-
ately.
Never carry the power tool by the dust extraction at-
u
tachment.
During operation, hold the power tool with fitted dust
u
extraction attachment not on the dust extraction at-
tachment, but always on the handle and auxiliary
handle of the power tool.
Note: The guide (4) is spring-loaded. The guide can spring
forward when the button (5) for drill bit length adjustment is
pressed.
Hold the power tool firmly with both hands and make
u
sure you have a stable footing. The power tool is more
securely guided with both hands.
Inserting/removing the drill bit (see figure B)
– Press the button (5) for drilling depth adjustment and pull
GDE 18V-16
the guide (4) all the way out.
1 600 A00 51N
– Release the button (5) again.
mm 4–16
– Slide the tip of the drill bit through the dust cap (2) from
mm 165 behind and then fit the bit into the drill chuck according to
the instructions of your power tool.
mm 100
– Before removing the drill bit, press the button (5) again
kg 1.2
and pull the guide (4) all the way out.
Bosch Power Tools