Wi-Fi Use - Haier HBW5719E Bedienungsanleitung

Wi-Fi Use

When display panel is on, a short push of the Wi-Fi button starts the sync and Wi-Fi LED
starts blinking. Follow instructions on the App to complete the connection.
Long acoustic feedback (1 sec) confirms that the connection is established and the LED
stays on fixed.
If the Wi-Fi has not been configured yet, when the refrigerator turns on, it
will automatically enter the configuration mode and keep this status for 30 minutes.
To use the configuration mode:
Press the Wi-Fi key for 2s, the refrigerator enters the Wi-Fi configuration mode
•
and an acoustic signal is made. The Wi-Fi icon starts blinking.
Follow in app instructions to configure the Wi-Fi (see above).
•
• Once the Wi-Fi is configured and the connection established, the Wi-Fi icon is on
and fixed.
• After 30 minutes without performing any operation, the Wi-Fi will automatically
exit the configuration mode.
If the Wi-Fi has already been configured, it will automatically reconnect
•
according to the configuration information.
To reset the Wi-Fi, long press the Wi-Fi key and Mode for 2s, the Wi-Fi is reset and
an acoustic signal is made. After this, the Wi-Fi will automatically enter the configuration
state (Wi-Fi icon will start blinking again).
To turn off the Wi-Fi, press the Wi-Fi key for 3s.
Radio-module - Technical data
Frequency rate (OFR)
Channel frequencies
Maximum power(EIRP)
Radio equipment type is in compliance with Directive 2014/53/EU.
2400 MHz-2843.5 MHz
2412...2472 MHz(step size 5 MHz)
100 mW
EN 9