Other Functions - Würth JUMP PACK PRO Bedienungsanleitung

Manual override mode
Danger posed by spark build-up and severe heat.
Spark and reverse battery protection are
Â
deactivated in this function. Currents of up to
2,000 A possible.
¾ Use this function with extreme caution and only in
exceptional circumstances.
¾ Check the exact polarity of the vehicle battery
beforehand.
¾ Pay particular attention that the red positive
terminal clamp is connected to the positive terminal
and the black negative terminal clamp is connected
to the negative pole of the vehicle battery of the
vehicle.
¾ Never touch the red positive terminal clamp with
the black negative terminal clamp / ground point
on the vehicle.
¾ Do not use this function in the case of any
uncertainty.
Note
Manual override mode is used for deep-discharging
vehicle batteries (voltage below 2 V). If the voltage of
the vehicle battery is below 2 V, the boost LED (white)
is off [5].
▸ To activate the manual override function, press the manual over-
ride button [7] for 3 seconds.
3 The boost LED [5] starts to flash. The device has switched to
manual override mode.
Powerbank function
▸ Connect an external device such as a smartphone or tablet to
the USB output socket to charge the external device.

Other functions

DANGER!
17