Würth JUMP PACK PRO Bedienungsanleitung Seite 15

¾ For charging, use the supplied USB cable [8] in conjunction
with the supplied adapters (12 V or 230 V) or a suitable USB
interface.
¾ Switch the device off before connecting it for charging.
Note
Charge the device for 24 hours before using it for the
first time!
▸ Connect the USB-in charging socket of the device with the USB
cable [8] and the corresponding adapter.
Note
During charging, the charging status of the internal
battery is indicated by the four charge status LEDs.
3 The LEDs pulse slowly during the charging process until the
internal battery is fully charged.
3 Once full charging capacity has been reached, the green 100%
LED lights up permanently and the other LEDs (25%, 50%, 75%)
go out.
3 The green 100% LED flashes from time to time (charge
conservation).
▸ After charging, disconnect the device from the voltage source.
Remote start of a vehicle engine
Danger when working near to car batteries (lead
acid).
Batteries build up explosive gases during
Â
operation.
¾ Wear suitable protective clothing and eye
protection.
¾ Never smoke around the batteries, hold naked
flames to them, and avoid spark development.
Charging
Attention!
WARNING!
15