IFM Electronic Efector300 SI1002 Bedienungsanleitung Seite 30

I I Setting of the switch points
Switch point 1 (SP1) = lower value, setting range: LED 0 ... SP2
Switch point 2 (SP2) = upper value, setting range: SP1 ... LED 9
M S
1
1 time (= setting of SP1)
2 times (= setting of SP2)
M S
>5s
2
M S
3
*Decrease the switch point: Let the flashing and lit LEDs move to the
maximum setting value. Then the cycle starts again at the minimum setting
value.
- SP1: min. setting value = LED 0; max. setting value = LED "SP2".
- SP2: min. setting value = LED "SP1"; max. setting value = LED 9.
**Overflow: If the flashing LED and the lit LED exceed the maximum setting
value, the cycle starts again at the minimum setting value.
30
LO
LO
LO
LO
Press the Mode/Enter button.
HI
The current switch point is
indicated:
LED lit: coarse setting, LED
flashes: fine setting.
Press the Learn/Set button and
HI
keep it pressed
After 5 s the switch point is
increased* (incremental by
pressing briefly or scrolling by
holding pressed).
HI
Indication:
The flashing LED moves from left
to right. After LED 9 has been
reached the cycle starts again at
LED 0. The LED which is constantly
lit moves on by one position.**
Press the Mode/Enter button
briefly (acknowledgement).
HI
The set switch point becomes
effective; the unit passes into the
operating mode.