IFM Electronic Efector300 SI1002 Bedienungsanleitung Seite 18

• Installation
Mounting → page 22, electrical connection → page 24.
• HI-Teach
Apply the operating voltage.
After approx. 15 s the unit is ready.
Allow the medium to flow through the system at the required
maximmum flow rate (HI).
Press the Learn/Set button and
keep it pressed.
The green LEDs on the right and
on the left flash,
after 5 s the LED bar (green) fills
from left to right
(release the button as soon as
the first LEDs light).
The indication goes off briefly.
The unit stores the current flow
as maximum flow.
• The unit is ready for normal operation.
Further setting options (→ page 25)
• The HI-Teach is sufficient for the majority of waterbased applicati-
ons. Optional: adjustment to minimum flow (LO-Teach).
• Setting of the switch points.
• Setting for monitoring and optical indication of excess flow.
• Reset to factory settings.
18
Brief adjustment instructions
M S
LO
>5...<10
LO
LO
HI
HI
HI