Noise And Vibration Declaration Statement - Desoutter KA3-Serie Bedienungsanleitung

6159922410_04
Original instructions.
© Copyright 2018, Ets Georges Renault 44818
St Herblain, fR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT Of USE
This product is designed for removing or
polishing material using abrasives or polishing
attachments. The use of grinding wheel is
prohibited. No other use is permitted. For
professional use only.
TECHNICAl DATA
● See page 3.
Additional data:
Air flow
cfm
Air inlet
mm
Hose internal Ø
NOISE AND VIBRATION
DEClARATION STATEMENT
● See page 44.
Vibration level
Sound level
: Vibration levels.
a , a
hd h
K / K = K = 3 dB : Uncertainty.
pA WA
l : Sound pressure level.
pA
l : Sound power level.
WA
All values are current as of the date of this
publication. For the latest information please visit
www.desouttertools.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
l/s 9.5
20
" 1/4
6
" 1/4
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well as upon the exposure
time and the physical condition of the user.
We, Desoutter, cannot be held liable for the
consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration can
be found by accessing http://www.pneurop.eu/
index.php and selecting 'Tools' then 'Legislation'.
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so that
management procedures can be modified to help
prevent future impairment.
INSTAllATION
● See page 5.
The tool is designed for a maximum
operating pressure of 6.3 bar (90 psig).
The compressed air must be clean. The
installation of a filter is recommended.
● For maximum efficiency and
performance, comply with the
specification of the air hose
(antistatic hose).
Dust extraction
● Contact your local Desoutter representative
for more information.
OPERATING MODE
● See page 5.
The tools are fitted with a progressive throttle
action, this allows a low speed with a small
throttle opening which is ideal when commencing
a drilling operation.
● Always use a sharp drill at the correct drilling
speed.
The tool must not be operated at free
speed.
The tool is fully stopped only several
seconds after the on/off system has
been released.
6 / 48
English
02/2023