Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
TECHNICAL INFORMATION
If the equipment does not work,
please contact the Technical Service
Department and advise them of the
problem, indicating:
1 Serial number (S-No)
2 Appliance model. (Model)
You will find this information on the
rating plate on the lower part of the
oven when the door is opened.
The item that you have bought
meets the European directives on
electrical material safety (73/23/CEE)
and
electromagnetic
(89/336/CEE).
AENOR certifies the aptitude of
this appliance for the function and
guarantees the truthfulness of all data
shown in the energy card.
INSTALLATION
This information is intended for the
installer, as the person responsible for
assembly and electrical connection.
If you install the oven yourself,
the manufacturer will not be held
responsible for any possible damage.
Before Installation. Comments
 To unpack the oven, pull the tab
located on the lower part of the box and
to move it, hold by the lateral handles
and never by the oven door handle.
 A niche is required in the kitchen
unit as per the dimensions shown on
the figure, providing a minimum depth
of 550 mm. (See technical drawings on
the page 14).
their locations, the back part of the
unit corresponding to the shaded area
of technical drawings, must not have
any projections (reinforcements, pipes,
sockets, etc). (See the page 14).
covering of kitchen furniture must be
able to withstand temperatures up to
85°C.
compatibility
the mains supply correspond to that
indicated on the rating plate.
stand the maximum power indicated on
the rating plate.
shown in the following figure.
adequate earthing in accordance with
regulations in force.
out with an omnipolar switch, of an
adequate size for the current drawn.
There must be a minimum aperture
between contacts of 3 mm to enable
disconnection in the case of emergency,
cleaning or bulb exchange. Under no
circumstances must the earth wire pass
through this switch.
check that all the electrical parts of the
oven are working.
TECHNICAL PASSPORT
To fit multifunction ovens in
Â
 The adhesive used for the plastic
Electrical
Connection.
Requirements
The installer must check that:
The voltage and cycles of
Â
The electrical installation can
Â
The connection diagram is
Â
The electrical connection has
Â
 The connection must be carried
After connecting the electricity,
Electric oven
Legal
41
Werbung
Inhaltsverzeichnis
